ONKYO T-4555P ユーザーズマニュアル
20
Turning On and Listening to AM and FM Radio
—Continued
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
You can tune into AM and FM stations directly by
entering the appropriate frequency.
entering the appropriate frequency.
Adjusting the Antennas
When tuned into a station, the
TUNED indicator appears.
TUNED indicator appears.
TUNED
Tuning into Stations by Frequency
1
Press the [DIRECT TUNING] but-
ton.
ton.
(Actual display depends on country.)
2
Within 8 seconds, use the num-
ber buttons to enter the fre-
quency of the radio station.
ber buttons to enter the fre-
quency of the radio station.
For example, to tune into an FM sta-
tion at 87.5 MHz, press [8], [7], and
[5].
tion at 87.5 MHz, press [8], [7], and
[5].
Number buttons
DIRECT TUNING
Remote controller
Remote controller
2
1
Change the direction of the
antenna to achieve the best
possible reception.
antenna to achieve the best
possible reception.
Affix the antenna with a thumbtack. (Do not
push the thumbtack through the antenna.)
push the thumbtack through the antenna.)
Caution: Be careful not to prick your finger!
Adjusting the AM antenna
Adjust the location and position of the
AM antenna while listening to an AM sta-
tion to achieve the best possible reception.
AM antenna while listening to an AM sta-
tion to achieve the best possible reception.
Adjusting and installing the FM antenna
Choose a location for the FM antenna while
listening to an FM station.
listening to an FM station.
T-4555P_En.book Page 20 Wednesday, August 9, 2006 3:42 PM