ONKYO T-4555P ユーザーズマニュアル

 

18

 

You can use the following multi-room kits to control the 
T-4555P when it’s out of range of the remote controller:

• Multiroom AV distribution and control systems such 

as those made by Niles

 

®

 

 and Xantech

 

®

 

.

 

If the T-4555P is located in another room, installed in a 
cabinet, or out of range of its remote controller, you can 
use a commercially available IR receiver to pickup the 
remote controller signals and feed them to the T-4555P, 
as shown below.

Connect the IR receiver to the T-4555P as shown below.

 

If another component is out of range of its remote con-
troller, you can use a commercially available IR emitter 
to retransmit the remote controller signals received at 
the T-4555P’s IR IN, as shown below.

Connect the IR emitter to the T-4555P’s IR OUT, and 
place the IR emitter in front of the other component’s 
remote control sensor (usually located on its front 
panel), as shown below. See the instructions supplied 
with the IR emitter.

Only remote controller signals received by the 
T-4555P’s IR IN are fed through to the IR OUT. Signals 
picked up by the T-4555P’s remote control sensor are 
not output.

IR IN

T-4555P

Inside 

cabinet

Remote controller

Connecting
block

IR receiver

: Signal flow

T-4555P

from connecting block

Miniplug cable

IR IN

IR OUT

Connecting 
block

IR receiver

T-4555P

IR emitter

Remote controller

Other 

component

: Signal flow

T-4555P

Remote control

Other component

sensor

from connecting block

Miniplug cable

Miniplug

IR emitter

IR Emitter

:Signal flow

T-4555P_En.book Page 18 Wednesday, August 9, 2006 3:42 PM