Marantz SR5005 ユーザーズマニュアル
62
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
Other settings
Remote control settings
• When you connect a remote control receiver unit (purchased
separately) to the REMOTE CONTROL IN terminal of this unit, use
the following procedure to disable the remote sensor function of
this unit.
• The remote sensor function of remote control signals is enabled by
default.
o
p
ZONE2 ON/OFF
RETURN
ENTER
n
Disabling the sensor function of the remote control
1
To enable the remote signal sensor function, press
and hold
ZONE2 ON/OFF
and
RETURN
for 3 seconds.
“IR:< ENABLE >” is displayed.
2
Press o p to select “DISABLE”.
3
Press
ENTER
.
The sensor function of the remote control signal of this unit is
disabled.
disabled.
NOTE
If a remote control receiver unit (purchased separately) is not
connected, do not perform this setting. If you do, you will not be
able to operate this unit using the remote control.
connected, do not perform this setting. If you do, you will not be
able to operate this unit using the remote control.
n
Enabling the remote sensor function
1
To disable the remote signal sensor function, press
and hold
ZONE2 ON/OFF
and
RETURN
for 3 seconds.
“IR:< DISABLE >” is displayed.
2
Press o p to select “ENABLE”.
3
Press
ENTER
.
The sensor function of the remote control signal of this unit is
enabled.
enabled.
Switching the on-screen display
output mode
Set whether the menu is operated by the monitor connected to the
VIDEO OUT terminal or the monitor connected to the COMPONENT
VIDEO MONITOR OUT terminal.
• The factory setting is “Comp”.
VIDEO OUT terminal or the monitor connected to the COMPONENT
VIDEO MONITOR OUT terminal.
• The factory setting is “Comp”.
ENTER
o p
RETURN PURE DIRECT
1
Press and hold RETURN and PURE DIRECT for 3
seconds.
Corresponding to the video signal format settings,
“OSD Out: 0 Comp 1” or “OSD Out: 0 Video 1” is shown
in the display.
“OSD Out: 0 Comp 1” or “OSD Out: 0 Video 1” is shown
in the display.
2
Press
o
p
to change the settings according to the
connection method.
Comp
Set when the COMPONENT VIDEO MONITOR OUT
connector is connected to a TV.
Video
Set when the VIDEO OUT connector is connected
to a TV.
3
Press
ENTER
to enter the setting.
NOTE
When operating the on-screen display menu using the monitor
connected to the HDMI OUT terminal, either setting may be used
without problem.