Elite Video vsx33 ユーザーズマニュアル

En

There are cases where you may not be able to route HDMI signals through this receiver (this depends on the HDMI-
equipped component you are connecting–check with the manufacturer for HDMI compatibility information). 

If you aren’t receiving HDMI signals properly through this receiver (from your component), please try one of the 
following configurations when connecting up.

Configuration A
Use component video cables to connect the video output 
of your HDMI-equipped component to the receiver’s 
component video input. The receiver can then convert the 
analog component video signal to a digital HDMI signal 
for transmission to the display. For this configuration, 
use the most convenient connection (digital is 
recommended) for sending audio to the receiver. See the 
operating instructions for more on audio connections.

• The picture quality will change slightly during 

conversion.

Configuration B
Connect your HDMI-equipped component directly to the 
display using an HDMI cable. Then use the most 
convenient connection (digital is recommended) for 
sending audio to the receiver. See the operating 
instructions for more on audio connections. Set the 
display volume to minimum when using this 
configuration.

• If  your display only has one HDMI terminal, you can 

only receive HDMI video from the connected 
component.

• Depending on the component, audio output may be 

limited to the number of channels available from the 
connected display unit (for example audio output is 
reduced to 2 channels for a monitor with stereo audio 
limitations).

• If you want to switch the input function, you’ll have to 

switch functions on both the receiver and your 
display unit.

• Since the sound is muted on the display when using 

the HDMI connection, you must adjust the volume on 
the display every time you switch input functions.

Synchronized operation not 
possible using Control with 
HDMI function.

• Check the HDMI connections.
• The cable may be damaged.
• Select ON for the Control with HDMI setting (see HDMI Setup on page 56).
• Select ALL for the Control Mode with HDMI setting (see HDMI Setup on page 56).
• Turn the TV’s power on before turning on this receiver’s power.
• Set the TV side Control with HDMI setting to ON (see TV’s operating instructions).
• VSX-33 only: Connect the TV to the HDMI OUT 1 terminal and set the HDMI output to HDMI OUT 
1. Then turn on first the TV’s power, then this receiver’s power.

The folders/files stored on a 
USB memory device are not 
displayed.

The folders/files are currently stored in a region 
other than the FAT (File Allocation Table) region.

Store the folders/files in the FAT region.

The number of levels in a folder is more than 8.

Limit the maximum number of levels in a folder to 
8 (page 43).

There are more than 30 000 folders/files stored in 
a USB memory device.

Limit the maximum number of folders/files stored 
in a USB memory device to 30 000 (page 43).

The audio files are copyrighted.

Copyrighted audio files stored on a USB memory 
device cannot be played back (page 43).

VSX-33_UXJCB.book  96 ページ  ２０１０年３月９日　火曜日　午前１０時３９分