Integra DTR-7.4 ユーザーズマニュアル

69

In order to use the remote controller to control the 
DTR-7.4 from a remote location, you will need to pre-
pare a multi-room kit (sold separately) such as one of 
those given below:
• Onkyo’s Multi-Room System kits (IR Remote 

Controller Extension System)

• Multiroom A/V distribution and control system such 

as those from Niles

®

 and Xantech

®

RF Receivers also can be used with the remote controller 
to control the DTR-7.4 from a remote location. To use 
RF Receivers, set the Transmission Signal Format set-
ting to “RF.” (See page 70 for details.)

If the DTR-7.4 is located inside a cabinet or other enclosure 
where the infrared rays from the remote controller cannot 
enter, then operation with the remote controller will not be 
possible. In such a case, it will be necessary to install a 
remote sensor at a location outside of the cabinet that the 
infrared rays from the controller can reach.
With this connection, select “Main” for the 
Hardware Setup 

→ Remote Setup → Position in the 

The IR IN input allows you to control the DTR-7.4 from 
the remote zone (Zone 2) with the remote controller even 
though the remote zone may be on the other side of the 
building from the main zone. The diagram below shows 
how to make the proper connections for the remote zone.
With this connection, select “Zone 2” for the 
Hardware Setup 

→ Remote Setup → Position in the 

Make the connection as shown below. Do not plug in any 
equipment to the power outlet until all the connections 
are complete.

In this situation, you will need to use a commercially 
available IR emitter. Connect the mini plug of the IR 
emitter to the IR OUT terminal on the DTR-7.4 and then 
place the IR emitter on the remote sensor of the 
component or facing it. When the IR emitter is 
connected, only the signal input to the IR IN terminal is 
output to the IR OUT terminal. The signal input from the 
remote sensor on the front of the DTR-7.4 will not be 
output to the IR OUT terminal.