ONKYO tx-nr545 ユーザーズマニュアル

"Initial Setup" automatically starts on the TV when you first 

turn the unit on.

Language Select
 English
 Deutsch
 Français
 Español
 Italiano
 Nederlands
 Svenska

Exit

SETUP

Initial Setup

Settings proceed in the following order:

 

● Automatic calibration for optimum speaker settings

 

● Checking that each input source is connected correctly

 

● HDMI link function settings

 

● Settings required to operate other AV Components with 

the Remote Controller

 

● Checking network connections

 

● Wi-Fi settings

¼



Firmware update notification: If the unit is connected via LAN and there 

is firmware update available, the "Firmware Update Available" message will 

appear. To execute updating, select "Update Now" with the cursor buttons of 

the remote controller and press ENTER.  

The unit automatically turns itself into standby mode about 3 minutes after 

"Completed!" appears on the display, and updating will be complete.

Setup is performed as a series of responses to questions 

asked by the unit. Select the item with the cursors of 

the remote controller and press ENTER to confirm your 

selection. To return to the previous screen, press RETURN.

 

● You need to use HDMI connection between the unit and 

TV.

 

● Switch the input on the TV to that assigned to the unit.

Select the language first. Next, a summary of the initial 

settings is displayed. Select "Yes" in this screen and press 

ENTER on the remote controller.

Welcome to initial setup.
Have you connected all the speakers and devices?
Before starting, please connect speakers and sources.
Now, would you like to start initial setup?
1st Step : AccuEQ Room Calibration
2nd Step : Source Connection
3rd Step : Remote Mode Setup
4th Step : Network Connection

Yes
No

Initial Setup

Exit

SETUP

Re-doing initial setup: If you terminate the 

procedure on the way or change the setting made in 

the initial setup and want to call up the setup wizard 

again, press 

RECEIVER and then SETUP on the 

remote controller, select "8. Miscellaneous" - "Initial 

Setup", and press ENTER.

1 

The test tone coming from each speaker will be measured 

to enable setting of the number of speakers, volume 

level, each speaker's optimum crossover frequencies, 

and distance from the primary listening position, and also 

enable correction of distortion caused by the room acoustic 

environment.

 

● You cannot return to the previous screen during speaker 

setup, even if you press RETURN.

AccuEQ Room Calibration
 This step you can automatically calibrate
 your room to get correct surround sound.
 Would you like to calibrate your room now
 or later?

Do it Now
Do it Later

Initial Setup

Exit

SETUP

When the screen above is displayed, before starting the 

procedure, place the supplied speaker setup microphone 

at the measurement position  by referring to the following 

figure.

Listening area

Measurement position 

with microphone

¼



Correct measurement will not be possible if the microphone is held 

by hand. Measurement is not possible if headphones are being used.