Madrigal Imaging N380S ユーザーズマニュアル

6

Unpack your Nº380S Preamplifier and keep all packing materials for future trans-
port. Locate and remove all accessory items from the cartons. Accessories include:

°

Included with your new Mark Levinson preamplifier is a pair of knit, white
gloves designed to assist you in the initial unpacking and placement of your new
purchase. Please accept them as a token of our appreciation for having purchased
one of our products.

Using the supplied 

5

⁄

64

" Allen key, remove the two screws in the bottom end cap

of the remote control (i.e., the end opposite the IR transmitter lens). Insert the
two alkaline batteries found in the Accessories box, being careful to follow the
polarity indications given on the inside of the battery compartment. Replace the
end cap and the screws, using the Allen key.

If at some point you notice that your remote control seems not to be performing
as well as it once did, its batteries are probably running low. Check the batteries
periodically, and replace batteries before they are “dead.” (Fully discharged batter-
ies are prone to leaking corrosive chemicals—the greenish “gunk” you may have
seen around battery terminals of other remote controls.)

The Nº380S should be placed close to your source equipment, thus keeping in-
terconnect cabling short. We strongly recommend shelf mounting to allow for
proper ventilation.

The Nº380S is designed for continuous operation, which is why it features a

mode rather than a full “off” mode—it is designed to be connected to

the AC mains at all times for the best performance.

Be sure to allow 3 to 4 inches of clearance above the Nº380S to allow heat dissi-
pation through air circulation.

Drawings are included in this manual to facilitate special installations and custom
cabinetry (see “Dimensions”).