Madrigal Imaging N380S ユーザーズマニュアル
9
display
intensity
monitor
record select
balance
inverted
polarity
mono
1
2
3
4
5
6
standby
mode
mute
9
8
7
3
2
1
5
10
6
4
PREAMPLIFIER Nº 380S
Front Panel
1
DISPLAY INTENSITY BUTTON
Cycles among four levels of brightness (including “off”) for the display, al-
lowing adjustment for various ambient lighting conditions. When “off,” the
display will turn on for a few seconds whenever a setting is changed. When
used in conjunction with certain compatible Mark Levinson components,
this button will control the display intensity of all linked components. (For
more information, see “Linked Functions.”)
Cycles among four levels of brightness (including “off”) for the display, al-
lowing adjustment for various ambient lighting conditions. When “off,” the
display will turn on for a few seconds whenever a setting is changed. When
used in conjunction with certain compatible Mark Levinson components,
this button will control the display intensity of all linked components. (For
more information, see “Linked Functions.”)
2
ALPHANUMERIC DISPLAY
Provides a wide range of information concerning the operational status of
the Nº380S. The information displayed depends on the operating mode the
Nº380S is in (determined by the
Provides a wide range of information concerning the operational status of
the Nº380S. The information displayed depends on the operating mode the
Nº380S is in (determined by the
mode
button). The information displayed
is summarized below:
monitor
Selected (audible) Source and Volume
record Select
“RECD” and Source to be recorded
balance
Direction and Magnitude of Offset
In addition, when used with Mark Levinson power amplifiers that incorpo-
rate our communications link circuitry, this display is used to indicate the
presence of a fault condition (if any) in the amplifier. Please refer to the
owner’s manual of your amplifier for more information. For more detailed
information on the preamplifier’s use of this display, see “Operational
Modes.”
rate our communications link circuitry, this display is used to indicate the
presence of a fault condition (if any) in the amplifier. Please refer to the
owner’s manual of your amplifier for more information. For more detailed
information on the preamplifier’s use of this display, see “Operational
Modes.”