ONKYO A-1VL ユーザーズマニュアル

 

10

 

Use an analog audio cable (RCA/phono) to connect the 
A-1VL’s CD L/R inputs to the analog audio outputs on 
your CD player, as shown.

Use an analog audio cable (RCA/phono) to connect the 
A-1VL’s LINE 1 L/R inputs to the analog audio outputs 
on your component such as a TV, as shown.

Note:
If your TV has no audio outputs, connect the A-1VL to 
your VCR and use its tuner.

Use an analog audio cable (RCA/phono) to connect the 
A-1VL’s LINE 2 IN L/R inputs to the  MD recorder or 
cassette recorder’s outputs, and use another analog 
audio cable (RCA/phono) to connect the A-1VL’s LINE 
OUT L/R outputs to the cassette or MD recorder’s 
inputs, as shown.

Use an analog audio cable (RCA/phono) to connect the 
A-1VL’s TUNER L/R inputs to the analog audio out-
puts on your tuner, as shown.

The A-1VL’s phono inputs are for use with moving 
magnet (MM) type cartridges.
Use an analog audio cable (RCA/phono) to connect the 
A-1VL’s PHONO L/R inputs to the audio outputs on 
your turntable, as shown. Remove the shorting pin plugs 
before connecting your turntable. 

Notes:
• If your turntable has a ground wire, connect it to the 

GND screw on the A-1VL. With some turntables, 
connecting the ground wire may cause hum, in which 
case it should be disconnected.

• If your turntable has a moving coil (MC) type 

cartridge, you’ll need a commercially available MC 
phono preamp. Connect the phono preamp to your 
turntable, and then connect the phono preamp to the 
A-1VL’s PHONO L/R inputs.