JVC RX-E100SL ユーザーズマニュアル

CONTROL

5

/

∞

/

3

/

2

Display

SETTING

Surround mode is automatically activated when a multichannel
digital signal comes into this receiver through the digital terminal.
You can enjoy Surround mode simply by selecting the source (with
digital input selected for that source) — Auto Surround.

To activate Auto Surround, follow the procedure below.

Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.

The CONTROL buttons now work for basic
settings.

∞ (or 5) repeatedly until

*

* “OFF” is the initial setting. If you have already changed the

setting, “ON” will be shown.

3 (or 2) to select “ON.”

• Each time you press the button, Auto Surround turns “ON” or

“OFF.”

: • If multichannel signals come in, an appropriate

Surround mode will be turned on

• If Dolby Digital 2 channel or DTS 2 channel

signals come in, “STEREO” will be selected.

• If linear PCM signals come in, nothing will

change.

: Select this to deactivate Auto Surround.

• This function does not take effect in the following cases:

– While playing an analog source.
– While selecting “DGTL DTS” or “DGTL D.D.” as the fixed digital

input mode (see page 11).

• If Surround mode is automatically activated by Auto Surround,

another DSP mode in use will be canceled temporarily. When
multichannel digital signals stop coming in, the selected surround
mode is canceled, and the previous DSP mode resumes.

• If you press SURROUND ON/OFF (SURROUND on the remote

control) or DSP MODE with Auto Surround activated, Auto
Surround will be canceled temporarily for the currently selected
source.
Auto Surround setting will be restored in the following cases.
– When you turn off and on the unit,
– When you change the source, and
– When you reset “AUTO SR” to “ON” again.

Repeat step 1 and 2, then select “OFF” in step 3.

EN08-16.RX-E100SL[J]_f

01.3.7, 2:49 PM

16