JVC SP-UXG200 ユーザーズマニュアル

Thank you for purchasing a JVC product.
Please read all instructions carefully before operation, to 
ensure your complete understanding and to obtain the best 
possible performance from the unit.

• Install in a place which is level, dry and neither too hot nor 

too cold—between 5°C (41°F)  and 35°C (95°F).

• Install the System in a location with adequate ventilation to 

prevent internal heat buildup inside the System.

• Leave sufficient distance between the System and the TV.
• Keep the speakers away from the TV to avoid interference 

with TV.

• When unplugging the System from the wall outlet, always 

pull on the plug, not the AC power cord.

Moisture may condense on the lenses inside the System in 
the following cases:
• After starting to heat the room
• In a damp room
• If the System is brought directly from a cold to a warm place
Should this occur, the System may malfunction. In this case, 
leave the System turned on for a few hours until the moisture 
evaporates, unplug the AC power cord, then plug it in again.

• Should any metallic object or liquid fall into the System, 

unplug the AC power cord and consult your dealer before 
operating any further.

• If you are not going to operate the System for an extended 

period of time, unplug the AC power cord from the wall outlet.

If anything goes wrong, unplug the AC power cord and 
consult your dealer.

To make this manual as simple and easy-to-understand as 
possible, we have adapted the following methods:
• Button and control operations are explained as listed in the 

table below. In this manual, the operations using the 
remote control is mainly explained; however, you can use 
the buttons and controls on the main unit if they have the 
same (or similar) name and marks.

• Some related tips and notes are explained later in the 

sections “Learning More about This System” and 
“Troubleshooting,” but not in the same section 
explaining the operations. If you want to know more about 
the functions, or if you have a doubt about the functions, go 
to these sections and you will find the answers.

DO NOT install the System in a location near 
heat sources, or in a place subject to direct 
sunlight, excessive dust or vibration.

DO NOT handle the AC power cord with wet 
hands.

For safety, observe the following carefully:
• Make sure there is good ventilation around 

the main unit. Poor ventilation could 
overheat and damage the System.

• DO NOT block the ventilation openings or 

holes. If they are blocked by a newspaper 
or cloth, etc., the heat may not be able to 
get out.

DO NOT disassemble the System since there 
are no user serviceable parts inside.

Indicates that you press the button 
briefly.

Indicates that you press the button 
briefly and repeatedly until an option 
you want is selected.
Indicates that you press one of the 
buttons.

Indicates that you press and hold the 
button for specified seconds.
• The number inside the arrow indicates the 

period of press (in this example, 2 seconds).

• If no number is inside the arrow, press and 

hold until the entire procedure is complete 
or until you get a result you want.

• Indicates that you turn the control 

toward the specified direction(s).

Indicates that this operation is only possible 
using the remote control.
Indicates that this operation is only possible 
using the buttons and controls on the main 
unit.

2

 sec.

UX-G200[J].BOOK  Page 1  Tuesday, December 2, 2008  3:05 PM