JVC CA-DXU8 ユーザーズマニュアル

@

 

• When connecting the speaker cords, match their polarity 

with that of the speaker terminals: blue/red/white to (+) and 
black to (–).

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the System.

• The supplied speakers and subwoofer are magnetically 

shielded to avoid color distortions on TVs. However, if not 
installed properly, it may cause color distortions. So, pay 
attention to the following when installing the speakers.
– When placing the speakers near a TV set, turn off the 

TV’s main power switch or unplug it before installing the 
speakers.
Then wait at least 30 minutes before turning on the TV’s 
main power switch again.

Some TVs may still be affected even though you have 
followed the above instruction. If this happens, move the 
speakers away from the TV.

¤

#

 

Plug the AC power cord to a wall outlet.

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT push or pull the speakers as this 

will damage the foot spacers at the bottom 
of the speakers.

1Push

2Insert

3Release

From front right speaker (black/blue)

From front left speaker (black/blue)

From left matrix 
surround 
speaker
(black/white)
(not supplied)

From right 
matrix surround 
speaker
(black/white)
(not supplied)

From subwoofer 
(black/red)

 

Use a screwdriver to rotate the 
voltage selector so that the voltage 
mark is pointing to the same voltage 
as where you are plugging in the unit. 
(See also the back cover page.)

DO NOT plug in before setting the voltage 
selector and all connection procedures are 
completed.

Voltage mark

DX-U6[U].book Page 5 Monday, March 26, 2007 2:22 PM