ONKYO T-433 ユーザーズマニュアル

 

9

 

The T-433 doesn’t have its own remote controller, but it 
can be controlled by using the RC-613S remote control-
ler that’s supplied with the Onkyo A-933 Integrated 
Amplifier. The T-433 and A-933 must be connected 
with an 

 cable and an audio cable for this to work.

When controlling the T-433 with the A-933’s remote 
controller, point the controller at the A-933’s remote 
control sensor, as shown.

 

• The remote controller may not work reliably if the 

A-933 is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in 
mind when installing.

• If another remote controller of the same type is used 

in the same room, or the A-933 is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything, such as a book, on the remote 

controller, because the buttons may be pressed inad-
vertently, thereby draining the batteries.

• The remote controller may not work reliably if the 

A-933 is installed in a rack behind colored glass 
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an 

obstacle between it and the A-933’s remote control 
sensor.

30

°

5m

30

°

RC-613S

A-933

Remote control

sensor

*En_T433_02.fm Page 9 Tuesday, February 15, 2005 3:09 PM