Denon ADV-M51 ユーザーズマニュアル

45

Either turn the SURROUND/SELECT dial or press the
SURROUND button on the remote control unit to select the
surround mode.

SURROUND / SELECT

PUSH - PARAM.

SURROUND

Main unit

Remote control unit

• The function switches as shown below.
• The function only changes in the “

Æ” direction when

operated from the remote control unit.

Start playback on the selected component.
• For operating instructions, refer to the component’s

manual.

• The volume can be adjusted within the range –60 to 0 to

+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may
not be possible to adjust the volume up to +18 dB.

Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.

M.VOLUME -20

VOLUME

Main unit

+

-

Remote control unit

The volume level is displayed
on the display.

• “DIG” lights when digital signals are input properly. If “DIG” is

flashing, check whether the connections are proper and whether
the input component’s power is on.

• In the AUTO mode

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

One of these lights, depending on
the input signal.

Lit

• DOLBY DIGITAL

• DTS

• PCM

• When playing CDs containing recordings of live concerts, etc., in

the  “AUTO” mode, the sound may be slightly broken at the
beginning. If this happens, switch to the “PCM” mode.

• If DTS-compatible CDs are played in the “PCM” mode, noise is

output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to “AUTO” or “DTS”.

• Noise may be generated at the beginning of playback and while

searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.

MENU / SET

Main unit

SURROUND / SELECT

PUSH - PARAM.

Main unit

STATUS

Remote control unit

2

To check the currently playing program source, etc.
Press the MENU/SET button. Display “STATUS” then turn
the SURROUND/SELECT control.

To perform this operation on the remote control unit, press
the STATUS button.

The current program source and surround settings are shown
on the display each time the button is pressed or turned.
(When the function is set to DVD, the information is also
displayed on the TV screen.)