Pyramid Car Audio CDR-38DX ユーザーズマニュアル

Page 03

Page 06

NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B installation.

1. Dashboard
2. Nut (5mm)
3. Spring Washer
4. Screw (5 x 25mm)
5. Screw

6. Strap

Be sure to use the strap to secure the 
back of the unit in place. The strap can 
be bent by hand to the desired angle.

7. Plain Washer
8. Fix the springs on each side.

DIN REAR-MOUNT (Method B)
Installation using the screw holes on the 
sides of the unit

Fastening the unit to the factory radio 
mounting bracket.

1. Select a position where the screw holes of 

the bracket and the screw holes of the 
main unit become aligned (are fitted), and 
tighten the screws at 2 places on each 
side. Use either truss screws 
(5 x 5mm) or flush surface screws (4 x 
5mm), depending on the shape of the 
screw holes in the bracket.

2. Screw
3. Factory radio mounting bracket
4. Dashboard or Console
5. Hook (Remove this part)

NOTE: If Press RESET button (21), the unit can't work yet, please use a cotton swab soaked in isopropyl 
alcohol to clean the socket on the back of the front panel.

SELECT MODE
Press SEL button (3) to change audio 
mode through volume, bass, treble, balance 
mode. Use VOL Up (4) and VOL Down (5) 
button to adjust the selected mode. When 
mode has not been adjusted for several 
seconds, display returns to normal radio or 
CD display.

Adjust volume level by using VOL Up (4) 
and VOL Down (5) buttons.

Press SEL button (3) one time. Adjust bass 
level by using VOL Up (4) and VOL Down 
(5) buttons.

Press SEL button (3) two times. Adjust 
treble level by using VOL Up (4) and VOL 
Down (5) buttons.

Press SEL button (3) three times. Adjust 
sound balance between left and right 
speakers by using VOL Up (4) and VOL 
Down (5) buttons.

 (optional)

Press SEL button (3) four times. Adjust 
sound balance between front and rear 
speakers by using VOL Up (4) and VOL 
Down (5) buttons.

MUTE
Press MUTE button (6) to mute down sound. 
Press it again to release this mode and recover 
previous volume level.

CD MODE/RADIO MODE
During CD operation, Press BND button (10) 
to switch to radio mode. During radio operation, 
when a compact disc is inserted in the Disc 
Slot (16), Press Play/Pause button (14) to 
switch to CD mode and start playing.

EQUALIZATION
Press EQ button (7) to turn to equalization 
function and to select desired audio mode. 
There are four kinds of modes as below:

LIQUID CRYSTAL DISPLAY 
The LCD (19) can show the current state of 
the unit.

FLASHING LED
If the front panel is not on the main unit, LED 
(20) will be flashing.

RESET BUTTON FUNCTION
RESET button (21) is placed on the housing 
and must be activated with either a ballpoint 
pen or thin metal object. The RESET button 
(21) is to be activated for the following 
reasons:

· Initial installation of the unit when all wring is 

completed.

· All the function buttons do not operate.
· Error symbol on the display.

(Volume)

(Volume)

(Bass)

(Treble)

(Balance)       (Fader)

(Bass)

(Treble)

(Balance)