ONKYO TX-SR702 操作ガイド

 

39

 

This chapter explains the settings that you need to make before using the AV receiver.

With the supplied speaker setup microphone, the Auto-
matic Speaker Setup function can measure the test tone 
output by each speaker and automatically determine the 
number of speakers connected, their sizes, the distance 
from each speaker to the listening position, and so on.
Before using this function, connect and position all your 
speakers.

 

On the TV, select the input to which the 
AV receiver is connected.

 

• Wait at least five seconds after turn-

ing on the AV receiver before plug-
ging in the speaker setup 
microphone.

• Make sure the microphone is hori-

zontal.

• If there’s an obstacle between the 

microphone and any speaker, the 
automatic setup will not work cor-
rectly. Set the room how you would 
have it when enjoying a DVD.

• If the AV receiver was previously 

muted, the Muting function will be 
cancelled.

• The automatic setup cannot be used 

while a pair of headphones is con-
nected.

• By putting the microphone close to 

where your ears would normally be 
at the listening position, a more accu-
rate setup can be achieved. If you use 
a tripod or level table, you can adjust 
the height of the microphone.

MIC 
position

Auto Speaker Setup

------------------------
    Push Enter:Start

TX-NR702,602_En.book Page 39 Tuesday, September 7, 2004 1:18 PM