ZyXEL Communications 3.1 ユーザーズマニュアル

 Chapter 39 File Manager

ZyWALL (ZLD) CLI Reference Guide

The following table lists the commands that you can use for file management.

File Manager Commands Summary

apply /conf/file_name.conf [ignore-

error] [rollback]

Has the ZyWALL use a specific configuration file. You must still use the 

write 

command to save your configuration changes to the flash (“non-

volatile” or “long term”) memory.

Use this command without specify both ignore-error and rollback: this 
is not recommended because it would leave the rest of the configuration 
blank. If the interfaces were not configured before the first error, the 
console port may be the only way to access the device.

Use ignore-error without rollback: this applies the valid parts of the 
configuration file and generates error logs for all of the configuration file’s 
errors. This lets the ZyWALL apply most of your configuration and you can 
refer to the logs for what to fix.

Use both ignore-error and rollback: this applies the valid parts of the 
configuration file, generates error logs for all of the configuration file’s 
errors, and starts the ZyWALL with a fully valid configuration file.

Use rollback without ignore-error:  this gets the ZyWALL started with 
a fully valid configuration file as quickly as possible.

You can use the “apply /conf/system-default.conf” command to reset 
the ZyWALL to go back to its system defaults.

copy {/cert | /conf | /idp | /

packet_trace | /script | /tmp}file_name-

a.conf {/cert | /conf | /idp | /

packet_trace | /script | /tmp}/

Saves a duplicate of a file on the ZyWALL from the source file name to the 
target file name. 

Specify the directory and file name of the file that you want to copy and 
the directory and file name to use for the duplicate. Always copy the file 
into the same directory. 

copy running-config startup-config

Saves your configuration changes to the flash (“non-volatile” or “long 
term”) memory. The ZyWALL immediately uses configuration changes 
made via commands, but if you do not use this command or the write 
command, the changes will be lost when the ZyWALL restarts.

copy running-config /conf/file_name.conf

Saves a duplicate of the configuration file that the ZyWALL is currently 
using. You specify the file name to which to copy.

delete {/cert | /conf | /idp | /

packet_trace | /script | /tmp}/file_name

Removes a file. Specify the directory and file name of the file that you 
want to delete. 

dir {/cert | /conf | /idp | /

packet_trace | /script | /tmp}

Displays the list of files saved in the specified directory.

rename {/cert | /conf | /idp | /

packet_trace | /script | /tmp}/old-

file_name {/cert | /conf | /idp | /

packet_trace | /script | /tmp}/new-

Changes the name of a file. 

Specify the directory and file name of the file that you want to rename. 
Then specify the directory again followed by the new file name. 

rename /script/old-file_name /script/

Changes the name of a shell script. 

run /script/file_name.zysh

Has the ZyWALL execute a specific shell script file. You must still use the 

write

 command to save your configuration changes to the flash (“non-

volatile” or “long term”) memory. 

schedule-run 1 file_name.zysh {daily | 

monthly | weekly} time {date | sun | mon 

| tue | wed | thu | fri | sat}

Has the ZyWALL execute the specified specific shell script file at the the 
specified time. You must still use the 

write

 command to save your 

configuration changes to the flash (“non-volatile” or “long term”) 
memory.