ZyXEL Communications 3.1 ユーザーズマニュアル

 Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

The following commands show you how to set up VLAN vlan100 with the following parameters: 
VLAN ID 100, interface ge1, IP 1.2.3.4, subnet 255.255.255.0, MTU 598, gateway 2.2.2.2, 
description "I am vlan100”, upstream bandwidth 345, and downstream bandwidth 123.

This section covers commands that are specific to bridge interfaces. Bridge interfaces also use 
many of the general interface commands discussed at the beginning of 

.

The following table identifies the values required for many of these commands. Other input values 
are discussed with the corresponding commands.

This table lists the bridge interface commands.

[no] vlan-id <1..4094>

Specifies the VLAN ID used to identify the VLAN. The 

no

 command clears the VLAN ID.

show port vlan-id

Displays the Ethernet interface VLAN settings.

interface Commands: VLAN Interfaces (continued)

Router# configure terminal

Router(config)# interface vlan100

Router(config-if-vlan)# vlan-id 100

Router(config-if-vlan)# port ge1

Router(config-if-vlan)# ip address 1.2.3.4 255.255.255.0

Router(config-if-vlan)# ip gateway 2.2.2.2

Router(config-if-vlan)# mtu 598

Router(config-if-vlan)# upstream 345

Router(config-if-vlan)# downstream 123

Router(config-if-vlan)# description I am vlan100

Router(config-if-vlan)# exit

Input Values for Bridge Interface Commands

The name of the interface.

Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 - N, where N 
equals the highest numbered Ethernet interface for your ZyWALL model.

The ZyWALL USG 200 and below models use a name such as wan1, wan2, opt, 

lan1, ext-wlan, or dmz.

VLAN interface: vlanx, x = 0 - 4094

bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces 
your ZyWALL model supports.

interface Commands: Bridge Interfaces

interface interface_name

Creates the specified interface if necessary and enters sub-command mode.