ZyXEL Communications 3.1 ユーザーズマニュアル

 Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

The following commands show you how to set up the auxiliary interface aux with the following 
parameters: phone-number 0340508888, tone dialing, port speed 115200, initial-string ATZ, 
timeout 30 seconds, username kk, password kk@u2online, chap-pap authentication, and 
description “I am aux interface”.

The following commands show how to dial, disconnect, and stop the auxiliary interface.

[no] phone-number phone

Specifies the phone number of the auxiliary interface. You can use 1-20 
numbers, commas (,), or plus signs (+). Use a comma to pause during dialing. 
Use a plus sign to tell the external modem to make an international call. The 

no

 command clears the phone number.

[no] port-speed {9600 | 19200 | 

38400 | 57600 | 115200}

Specifies the baud rate of the auxiliary interface. The 

no

 command sets the 

baud rate to 115200.

[no] username username

Specifies the username of the auxiliary interface. The 

no

 command clears the 

username.

: You can use alphanumeric, underscores (_), dashes (-), periods (.), 

and 

/@$

 characters, and it can be up to 64 characters long.

interface Commands: Auxiliary Interface (continued)

Router# configure terminal

Router(config)# interface aux

Router(config-if-aux)# phone-number 0340508888

Router(config-if-aux)# dialing-type tone

Router(config-if-aux)# port-speed 115200

Router(config-if-aux)# initial-string ATZ

Router(config-if-aux)# timeout 30

Router(config-if-aux)# username kk

Router(config-if-aux)# password kk@u2online

Router(config-if-aux)# authentication chap-pap

Router(config-if-aux)# description I am aux interface

Router(config-if-aux)# exit

Router# interface dial aux

Router# interface disconnect aux