Canon VB101 ユーザーズマニュアル

Ethernet
The same settings can be specified on the 
Basic Settings settings page.

"Use Ethernet"
Tick this checkbox to use Ethernet.

"Address Setting Method"
If you select "Auto Setting (Bootp)", the IP 
address is automatically acquired by the 
Bootp server after restart. If you select 
"Manual Setting", enter the IP address 
and subnet mask also.

"Give priority to Bootp option when 
deciding subnet mask."
If you tick this option, the subnet mask 
specified by the Bootp server is given 
priority over the subnet mask address 
specified below when "Auto Setting 
(Bootp)" is selected as the address 
setting method.

"Give priority to Bootp option when 
deciding gateway address."
If you tick this option, the gateway 
address specified by the Bootp server is 
given priority over the default gateway 
address specified below when "Auto 
Setting (Bootp)" is selected as the 
address setting method.

"IP Address"
Enter a network interface-specific IP 
address.

"Subnet Mask"
Enter the subnet mask specified for the 
network to be connected.

If you selected "Auto Setting (Bootp)" as 
the address setting method, check that 
the Bootp server has been started up.
Contact the network administrator for the 
IP address, subnet mask, and default 
gateway address settings.

Use this page to specify the settings for connecting to an Ethernet or PPP network.

For a LAN connection, specify Ethernet settings. For connections made with a modem, specify

PPP settings.

c

● If you are using Ethernet, take particular care with the IP address, subnet mask

● Turn the VB101 off before you insert a modem card.
● When you change an IP address, please re-access the Settings Title Page

→ P.36).