JVC DT-3D24G1 ユーザーズマニュアル

16

You can display the wave form monitor or vector scope, and compare and check the SDI IN 1/L and SDI IN 2/R input signals.

●

 Works in MIX mode. The operation to be performed differs in other modes. (→ page 9)

●

 Each time you press the SCOPE button, the display mode changes in the following order.

: Does not display the wave form monitor/vector scope.

: Tiles the wave form monitors of the images input into the SDI IN 1/L and SDI IN 2/R terminals.

: Tiles the vector scopes of the images input into the SDI IN 1/L and SDI IN 2/R terminals.

: Select this to display the differential of the signals from the SDI IN 1/L and SDI IN 2/R terminals in 

wave form monitor.

Select this to display the differential of the signals from the SDI IN 1/L and SDI IN 2/R terminals in 
vector scope.

Y

Y

Y

Parallel wave form monitor

Parallel vector scope

Difference wave form monitor

Difference vector scope

•  When the CAMERA ASSIST MENU “LR SWAP” is set to “ON”, L and R images of the parallel wave form monitor and vector scope are 

exchanged and then displayed.

•  The positions of the wave form monitor and vector scope can be changed in “POSITION” under the MAIN MENU “SCOPE SETTING.”
•  The wave form monitor and vector scope are not displayed in “R SHIFT” or “ANAGLYPH” of the CAMERA ASSIST MENU.
•  The vector scope is not displayed when the input signals are RGB.

When 3D is “ON”, the L and R lines measuring the visual difference between L and R images, and the pixels and percentage between the 
lines, are displayed. The following two modes are available for the line display: “Cursor mode” and “Grid mode.”

●

 Each time you press the 3D CURSOR button, the line display mode changes in the following order.

No display

Cursor mode

Grid mode

●

  The information (→ page 10) and SCOPE are not displayed in “Cursor mode” or “Grid mode.”

●

  The positions of the pixels and percentage can be changed in “POSITION” under the MAIN MENU “INFORMATION.”

The L, R, and H lines appear, which measure the visual difference.

●

 The H and L lines are fined dotted lines, and the R line a coarse dotted line. The selected line is displayed as a solid line.

●

  The line color changes when the line goes beyond “FAR LIMIT” or “NEAR LIMIT” under the MAIN MENU “3D SETTING.”

●

  The ratio of the difference between the L and R lines to the horizontal pixels appears in the percentage display.

●

  In the percentage display, “+” indicates the pop-up level (when the L line is placed on the right of the R line), and “–” the depth 

(when the L line is placed on the left of the R line).

H line (Group B)

H line (Group A)
(selected line)

Pixels/Percentage between L and R lines

L line (Group A)

R line (Group A)

R line (Group B)

L line (Group B)

-

DT3D24G1_EN.indb   16

DT3D24G1_EN.indb   16

11.1.25   0:53:50 PM

11.1.25   0:53:50 PM