JVC GET0602-001A ユーザーズマニュアル

ページ / 362
3
ELECTRICAL CONNECTIONS
電路連接
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious 
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
  Connect the colored leads of the power cord in the order specified in the illustration below.
2
  Connect the antenna cord.
3
  Finally connect the wiring harness to the unit.
接線前:仔細檢查汽車內的線路。不正確的接線會導致本機嚴重損壞。
電力線的引線和車身的連接器引線在顏色上可能有所不同。
1
  依照下圖所示之次序連接電源線的顏色導線。
2
  將天線的電線連接起來。
3
  最後,把配線束的插頭插在本機上。
Typical connections / 典型的接線方法
*
1
  Not supplied for this unit.
*
2
  Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power 
cannot be turned on.
*
1
  不隨本機提供。
*
2
  本機未安裝時,進行工作狀況檢查之前,必須把這導線接上,否則不能開啟電源。
15 A fuse
15 A 保險絲
Fan
風扇
Ignition switch
點火開關
To a live terminal in the fuse block connecting to the car battery (bypassing 
the ignition switch) (constant 12 V)
接至保險絲單元內的帶電端子,保險絲單元與車裝電池相連接(用於
旁路點火開關)(恆定 12 V)
To metallic body or chassis of the car
接至金屬體或汽車底盤
To an accessory terminal in the fuse block
接至保險絲單元內的附屬端子
To the remote lead of other equipment (200 mA max.)
連接至其他裝置的遙控導線(最大 200 mA)
To automatic antenna if any (250 mA max.)
接至自動天線(若有裝設)(最大 250 mA)
Fuse block
保險絲單元
To cellular phone system
連接至流動電話系統
To car light control switch 
連接至汽車車燈控制開關
Crimp connector
夾子接頭
To parking brake (see diagram  )
接至手剎車導線(參閱圖表  
Yellow *2
黃色 
*
2
Red
紅色
Orange with white stripe
橙色帶有白色條紋
Black
黑色
Light green
淺綠色
Brown
褐色
Blue with white stripe
藍色帶有白色條紋
Blue
藍色
Left speaker (rear)
左揚聲器 (後置)
Right speaker (front)
右揚聲器 (前置)
Left speaker (front)
左揚聲器 
(
前置
)
Right speaker (rear)
右揚聲器 (後置)
Gray with black stripe
灰色帶有黑色條紋
White
白色
White with black stripe
白色帶有黑色條紋
Green with black stripe
綠色帶有黑色條紋
Gray
灰色
Green
綠色
Purple with black stripe
紫色帶有黑色條紋
Purple
紫色
Rear ground terminal
本機後背接地端子
To external components 
(see diagram   )
接至外接裝置
(參閱圖表   
VIDEO IN
(see diagram   / 
參閱圖表   
DIGITAL OUT
(see diagram   / 參閱圖表  
LINE IN
(see diagram   / 
參閱圖表   
REAR OUT
(see diagram   / 
參閱圖表  
(see diagram   / 參閱圖表   
Position data output / 位置數據輸出
SUBWOOFER—Only for KW-AVX726/KW-AVX725 / 僅對應 KW-AVX726/KW-AVX725
(see diagram   / 參閱圖表   
VIDEO OUT
(see diagram   / 
參閱圖表   
Antenna terminal
天線端子
This terminal is used for controlling an external device by using the touch panel of this unit. This unit outputs the positional 
information detected on the touch panel through the POSITION OUT terminal. Refer to the instruction manual of the external 
device for details. JVC does not guarantee proper operations for the external device connected to the POSITION OUT terminal.
該端子使用本機的觸摸屏來控制外接裝置。本機從 POSITION OUT 端子輸出位置訊息,並在觸摸屏上被檢測到。關於
詳情,參閱外接裝置的使用手冊。JVC 不保證連接至 POSITION OUT 端子的外接裝置是否能正常操作。
CT_Instal_KW-AVX726[UT]2.indb   3
CT_Instal_KW-AVX726[UT]2.indb   3
08/12/25   16:33:17
08/12/25   16:33:17