Land Pride AR2510 ユーザーズマニュアル

12/09/15

3.

Install orifice plug (#12) into the cylinder port located 
near the base end of hydraulic cylinder (#11). Screw 
plug in until orifice bottoms out. Do not tighten.

4.

Screw elbow fittings (#9A & #9B) into both cylinder 
ports with O-rings facing ports. Do not tighten elbows 
until step #17.

5.

Attach base end of hydraulic cylinder (#11) to the 
Aerator’s main frame (#3) with 1" x 3 11/16" clevis 
pin (#10). Secure pin with hairpin cotter (#8). 

6.

Attach rod end of hydraulic cylinder (#11) to axle 
assembly (#1) with 1" x 2 3/4" clevis pin (#6). Secure 
clevis pin with cotter pin (#7). Bend one or more legs 
on the cotter pin to keep it from falling out.

Refer to Figure 1-4:
7.

Attach 3/4" adapter (#18) to hydraulic 
hoses (#13 & #14) and tighten.

8.

Attach quick disconnect couplings (#19) to 
adapters (#18) and tighten.

Refer to Figure 1-3:
9.

Insert the longer (201") hydraulic hose (#14) into the 
back opening end of the Aerator tongue. Push hose 
through tongue and out its front opening. 

10. Install flex guard (#15) over hydraulic hose (#14) at 

the cylinder end and push flex guard halfway into the 
tongue to protect hydraulic hose from wear.

11. Attach hydraulic hose (#14) to elbow fitting (#9B) and 

tighten.

12. Insert the shorter (185") hydraulic hose (#13) into the 

back opening end of the Aerator tongue. Push hose 
through tongue and out its front opening. 

13. Install flex guard (#15) over hose (#13) at the cylinder 

end and push flex guard halfway into the tongue to 
protect hydraulic hose from wear.

14. Attach hydraulic hose (#13) to elbow fitting (#9A) and 

tighten. 

Refer to Figure 1-4:
15. Pull hydraulic hoses (#13 & #14) out of opening (#17) 

until most of the slack in the hoses at the hydraulic 
cylinder have been removed.

16. Run hydraulic hoses through hose loop (#16).

Refer to Figure 1-3:
17. Orient elbows (#9A & #9B) to suit and tighten to 

hydraulic cylinder (#11).

Refer to Figure 1-5:
1.

Bolt SMV sign (#3) to mounting blade (#4) as shown 
with 1/4"-20 x 5/8" GR5 hex flange screws (#1) and 
hex flange nuts (#2). Tighten nuts to the correct 
torque.

2.

Insert mounting blade (#4) into mounting socket (#5).

30060

30061

30062