Woods Equipment CZ2461K ユーザーズマニュアル

NOTE:  Always use Woods replacement belts, not general purpose belts.  Woods belts 
are specially designed for use on this mower and will normally last longer.

1.  Remove floorplate.
2.   Set the cutterdeck in a middle height-of-cut posi-

tion.  

3.   Use a 3/8" ratchet and extension to back 

tensioning idler off to remove belt from idler.  
Remove belt from cutterdeck pulleys.

NOTE:  Use the 3/8" ratchet in the square hole A on 
the idler.

4.   Remove belt from clutch pulley. 

5.   Install the new belt by performing these steps in 

reverse order.

NOTE:  61" cutterdeck may require tension spring 
adjustment after belt installation.  See Belt tension

All belts are tensioned by spring loaded idlers and do
not require any adjustment except for the 61" 
cutterdeck. Use the eyebolt to adjust the spring
length to be between 6 3/4" - 7 1/2" as pictured.