Gardena R70Li ユーザーズマニュアル

English - 65

For a fully functional installation, the indicator lamp in the charging station must emit a solid green light. 
If something else appears, follow the troubleshooting guide below. 

There is more troubleshooting help on www.gardena.com. If you still need help with troubleshooting, 
please contact GARDENA Central Service. See Memo on page 4. 

Everything in order

No action required

The boundary loop is not connected 
to the charging station

Check that the boundary wire 
connector is fitted properly to the 
charging station. See 3.5 Connecting 
the boundary wire on page 27. 

Break in the boundary loop

Find out where the break is. Replace 
the damaged section of the boundary 
wire with a new loop wire and splice 
using an original coupler. See 
9.4 Finding breaks in the loop wire on 
page 68.

The guide wire is not connected to 
the charging station

Check that the guide wire connector 
is properly connected to the charging 
station. See 9.4 Finding breaks in the 
loop wire on page 68. 

Break in the guide wire

Find out where the break is. Replace 
the damaged section of the guide 
wire with a new loop wire and splice 
using an original coupler.

Interruption in the charging station's 
antenna

Contact GARDENA Central Service. 
See Memo on page 4.

Weak signal as the boundary wire is 
too long. Max length is 250 metres. 

No steps have to be taken if the 
robotic lawnmower operates as 
expected.

Shorten the boundary wire by 
reducing the working area or 
replacing islands with barriers the 
robotic lawnmower can collide with.

Weak signal due to damaged 
boundary wire

Since it is difficult to locate where the 
wire is damaged it is recommended 
to lay a new boundary wire for the 
entire working area. 

Defective circuit board in the charging 
station

Contact GARDENA Central Service. 
See Memo on page 4.