Husqvarna 96043002402 ユーザーズマニュアル

ASSEMBLY

ADJUSTMENT

KNOB

CUP WASHER

03035

030

SEAT

PAN

PADS

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment knob.
• Remove adjustment knob and cup washer securing

seat to cardboard packing and set aside.

•

Remove seat from the cardboard packing and set seat

aside. Remove the cardboard packing and discard.

• Place seat on seat pan so all three (3) bottom pads

are positioned over large slotted holes in pan.

• Push down on seat to engage pads in slots and pull

seat towards rear of tractor.

• Pivot seat and pan forward and as sem ble adjustment

knob and cup washer loosely. Do not tighten.

• Lower seat into operating position and sit in seat.
•

Slide seat until a comfortable position is reached which

allows you to press clutch/brake pedal all the way

down.

• Get off seat without moving its ad just ed position.
• Raise seat and tighten adjustment knob securely.

02021

FIG. 3

BATTERY

BOX DOOR

SEAT PAN

LABEL

TERMINAL

CHECK BATTERY (See Fig. 3)

• Lift seat pan to raised position and open battery box

door.

• If this battery is put into service after month and year

indicated on label (label located between terminals)

charge battery for minimum of one hour at 6-10 amps.

(See "BATTERY" in Maintenance section of this manual

for charging in struc tions).

FIG. 2

NOTE: You may now roll or drive your tractor off the skid.

Follow the ap pro pri ate instruction below to remove the

tractor from the skid.

WARNING: Before start ing, read, un der stand and fol low

all in struc tions in the Op er a tion section of this man u al. Be

sure tractor is in a well-ventilated area. Be sure the area in

front of tractor is clear of other peo ple and objects.

TO ROLL TRACTOR OFF SKID (See Op-

er a tion section for location and function of

con trols)

• Raise attachment lift lever to its highest po si tion.
• Release parking brake by depressing clutch/brake

ped al.

• Place gearshift lever in neutral (N) po si tion.
• Roll tractor forward off skid.

TO DRIVE TRACTOR OFF SKID (See Op-

er a tion section for location and func tion of

con trols)

WARNING: Before starting, read, un der stand and follow

all in struc tions in the Operation section of this manual. Be

sure tractor is in a well-ventilated area. Be sure the area in

front of tractor is clear of other people and objects.
•

Be sure all the above assembly steps have been com-

plet ed.

• Check engine oil level and fill fuel tank with gasoline.
•

Sit on seat in operating position, depress clutch/brake

pedal and set the parking brake.

• Place gear shift lever in neutral (N) position.
• Raise

tach ment lift lever to its highest position.

• Remove key from bag and start the engine (see "TO

START ENGINE" in the Operation section of this

manual). After engine has started, move throttle control

to idle (slow) position.

•

Depress clutch/brake pedal into full "BRAKE" position

and hold. Move gearshift lever to 1st gear.

• Slowly release clutch/brake pedal and slowly drive

tractor off skid.

•

Apply brake to stop tractor, set parking brake and place

gearshift lever in neutral position.

• Turn ignition key to "STOP" position.
Continue with the instructions that follow.