Husqvarna 15V2 AWD ユーザーズマニュアル
28 –
English
Maintenance
3
Loosen the spring (4) that tensions the V-belt and pry off
the belt.
the belt.
Simply reverse the procedure to fit the new belt.
Service position for the cutting unit
The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
1
Position the machine on flat ground. Apply the parking
brake. Adjust the cutting unit to the lowest cutting height
and lower the cutting unit.
brake. Adjust the cutting unit to the lowest cutting height
and lower the cutting unit.
2
Remove the front hood by removing the pin. (There are
complete instructions on using the service position inside
the front hood).
complete instructions on using the service position inside
the front hood).
3
Remove the two support wheels from under the front
hood.
hood.
4
Fit the support wheels on either side of the rear of the
cutting unit.
cutting unit.
5
Disengage the spring for the drive belt tensioning wheel.
Rider 15V2
Rider 15V2 AWD
6
Place a foot on the front edge of the cutting unit near the
wheel and raise the front edge of the unit to make it easier
to remove the lift strut.
wheel and raise the front edge of the unit to make it easier
to remove the lift strut.
!
WARNING! Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.