Cub Cadet 19A40002100 ユーザーズマニュアル

Move the wood block to either the left or right blade for 

6. 

stabilization and remove and replace the center blade so 

that side of the blade with part number faces the ground 

when the mower is in the operating position. 

NOTE: Save the three blades you just removed to use as 

replacements or to reinstall on the blade spindles when not 

using the bagger kit.

Note: If the deck is still flipped upside down with the blades 

exposed, it may be easiest to flip the deck back over to complete the 

following installation of the deck baffle and chute stop bracket.

Remove two of the self-tapping deck screws on the front 

1. 

right side of your deck. 
Install the front deck baffle using the hardware pack 689-

2. 

00163 included with this bagger kit. See Fig. 4-17.

Note: This bagger kit includes two deck baffles, one baffle is 

for the 50” deck and the other is for a 54” deck. Based on the 

deck that you have, install one of the following baffles using the 

directed hardware. The baffles may be identified by looking at 

the parts list on Page 16:

50” Mowing Deck, install deck baffle Part No.  703-05783 

• 

using two 710-3015 1/4-20 hex bolts and 712-04064 1/4-20 

flange lock nuts.
54” Mowing Deck, install deck baffle Part No.  703-06018A 

• 

using two 710-04484 self-tap hex bolts.

Always protect your hands while 

servicing blades by wearing heavy work gloves or 

using heavy rags.

NOTE: High-lift bagging blades are included in the grass-catcher 

kit. Replace the blades with these new blades and save the 

existing blades as replacements or to reinstall on the blade 

spindles when not using the bagger kit.

Remove cutting deck from beneath the tractor following 

1. 

instructions for Deck Removal in operator’s manual of the 

tractor. Gently flip the deck over to expose its underside.
Place a block of wood between the center deck housing 

2. 

baffle and the cutting blade to act as a stabilizer. See  

Fig. 4-16.

Use a 15/16” wrench to remove the hex flange nut that 

3. 

secures the blades to the blade spindle assemblies. See  

Fig. 4-16. 

The hex flange nut has a right-handed 

thread pattern. Do not attempt to force the nut in 

wrong direction; it may damage the nut and create a 

safety hazard.

Place a new blade on each spindle so that side of the blade 

4. 

with part number faces the ground when the mower is in 

the operating position. 
Note: This bagger kit includes two sets of blades, one set is 

for the 50” deck and the other is for the 54” deck. Based on 

the deck that you have, install one of the following blade 

sets. The blades can be identified by the part number 

stamped on each blade:

 

• 50” Mowing Deck, install Part No.  742-04056C

 

• 54” Mowing Deck, install Part No.  742-0679

Secure with the hex flange nut removed earlier. Use a 

5. 

torque wrench to tighten the hex flange nut between 70 to 

90 foot-pounds.