Cub Cadet 19A40002100 ユーザーズマニュアル

Locate the upright support bracket and the bag support 

assembly. Assemble it by following these steps:

Lay the bag support assembly topside down with the 

1. 

mounting bracket portion facing upwards.
Insert the notched end of the vertical support bracket into the 

2. 

bag support assembly, as in Fig. 4-3, and secure with a 5/16-18 

carriage bolt and 5/16-18 flange lock nut. See Fig. 4-4.

NOTE: References to left, right, front and rear of the tractor are 

from the operator’s position, unless otherwise stated.

Before assembly, place the tractor on a firm, level surface, 

• 

disengage the PTO, stop the tractor engine and set the 

parking brake.
For convenience, pivot the seat forward and leave it in 

• 

that position until the grass collector is fully mounted and 

assembled.

To assemble the bagger mounting assembly, locate the 

mounting assembly pack and follow these steps:

Attach the two hitch side brackets to the universal rear 

1. 

attachment bracket using four hex bolts and flange lock 

nuts.  With the hooks on the hitch side brackets pointing 

down, the tabs on the hitch plates should be pointing 

upwards. See Fig. 4-1.

Flip over assembly and mount the hitch support bracket to 

2. 

the mounting assembly using the hardware found in pack 

689-00087. See Fig. 4-2.
Note: It might be easier during the mounting stage to 

leave this hardware only finger tight to facilitate lining up 

the hitch hole for the clevis pin.  You will be instructed to 

tighten this hardware later in this manual.