Dimension One Spas Sarena Bay ユーザーズマニュアル

2003 Sarena Bay™ 

Export Owner’s Manual 

 

 

 

 

 

 

 
The “SUMMER MODE” feature temporarily disables the circulation pump 
“Cool Off” cycle. During hot weather the spa can experience “Heat Creep”. 
Heat creep is caused when the spa, during normal maintenance operations, 
cannot dissipate more heat than is generated. This may cause the spa 
temperature to exceed the set temperature and cause a “Cool Off” cycle. In 
order to prevent the water from becoming cloudy due to the circulation pump 
being turned off by the “Cool Off” cycle, the spa can be set to bypass the 
“Cool Off” cycle. This is accomplished by setting the spa in the “SUMMER 
MODE”.  
 
To initiate a “SUMMER MODE”, use the Up and Down Buttons to set the 
temperature to 15°C (≅59° F). The Digital Display Window will indicate 
“SUMMER MODE”. In this mode the pump will run continuously until the 
water temperature reaches 41° C (≅107°F) and then turn off. It will remain off 
until the water temperature reaches 38° C (≅102° F) at which point the pump 
turns on. 

 

 

 
The “STANDBY” mode allows the user to clean the filter without turning off 
power to the spa. This feature disables all automatic and manual functions. 
 
To enter the “STANDBY” mode press and hold the Dimension One Spa’s 
ICON Logo® Button for 5 seconds. To exit the mode, press and hold the 
Logo Button for 5 seconds.  
 
If you do not exit the mode manually, the spa will automatically return to 
normal functionality after 24 hours. 
 

 

 

 
The “Smart Winter” mode is not affected by the use of the 
“Standby”: mode. 

Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through 
customizing your hot tub to your exact needs. To initiate the programming sequence at any time, push and 
hold the Program Button for 3 seconds. If, within 10 seconds, you do not proceed with the hot tub 
programming, the hot tub will automatically exit the programming sequence and revert to the pre-set factory 
default settings. To exit the programming sequence at any time, push the Enter Button or do not press any 
button for 10 seconds. Any programming changes made up to that point are saved. 

After holding the PROGRAM Button, the top line of the Digital Display Window will read “SET TIME OF 
DAY” and the bottom line will read “PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO 
SELECT NEXT FUNCTION - PUSH ENTER TO EXIT ”. Push the UP or DOWN Buttons to engage the 
time setting mode. The time screen will appear with “hours” (_ _.00) flashing on and off. Push the UP or 
DOWN Button to increase or decrease the number until the desired hour appears. When the desired 
number is displayed, push the LIGHT Button to accept the selection and change the flashing number to the 
“ten minute” place (12:_0). Adjust the number with the UP or DOWN Button in the same manner as the 
hour number. When the desired indicator is displayed, push the LIGHT Button to accept the selection and 
change the flashing number to the “minute” place (12:1_). Adjust this number with the UP or DOWN 

 

28