North Star M157477A ユーザーズマニュアル

ページ / 17
 
14
 Maintenance 
 
Maintenance Mode 
Before performing any maintenance on the pressure washer, it must be placed in maintenance mode. 
1.) Turn off engine. 
2.) Turn off water supply. 
3.) Squeeze trigger to relieve system pressure. 
4.) Unplug spark plug wire from spark plug. (see engine owner’s manual) 
 
Maintenance Schedule 
What to Check  When To Check 
What to Do 
Inlet Filter 
Each Use 
Visually inspect and clean inlet filter with clear water. 
 
Pressure Hose 
 
Each Use 
Visually inspect pressure hose and hose couplings. Replace 
hose if any of the following is evident:  
hose coupling is damaged, wire mesh is exposed or damaged, 
hose is permanently kinked or flattened, outer hose cover is 
blistered or loose. 
Bolts 
Each Use 
Tighten any loose bolts. 
Engine Oil 
See engine 
manual 
See engine manual for oil change intervals, see Maintenance 
section of this manual for oil change instructions. 
Pump Oil 
Never 
The pump’s crankcase is sealed; oil changes are not required. 
 
Cleaning/Replacing the Nozzle Orifice 
1.) Place pressure washer in 
maintenance mode. (see above) 
2.) Insert a 2mm hex wrench into orifice 
and turn counter-clockwise to remove 
orifice from nozzle. 
-  To clean orifice, remove any debris 
and soak in descaling solution to 
remove hard water deposits. 
-  To replace orifice, order p/n 
PD38780 from NorthStar Customer 
Service, 1-800-270-0810 
3.) Use 2mm hex wrench and turn 
clockwise to reinstall orifice. 
 
 
 
 
 
 
 
 
2mm hex 
wrench