John Deere ST1332 ユーザーズマニュアル

23

MTF−051059L

1. For optimum snow blower efficiency, adjust ground

speed, not the throttle. REMEMBER − if the wheels slip,

forward speed will be reduced. The engine is designed

to deliver optimum performance at full throttle and must

be run at this power setting at all times.

2. Most efficient snowblowing is accomplished when snow

is removed immediately after it falls.

3. For complete snow removal, slightly overlap each swath

previously taken.

4. Snow should be discharged downwind whenever pos-

sible.

5. For normal usage, set the skids one−eighth inch (3 mm)

below the scraper bar. For extremely hard−packed snow

surfaces, the skids may be adjusted upward to insure

cleaning efficiency.

6. On gravel or crushed rock surfaces, the skids should be

set at 1−1/4 inch (32 mm) below the scraper bar (see To

Adjust Skid Height, in the Adjustment/Repair section in

this manual). Rocks and gravel must not be picked up

and thrown by the machine.

7. After the snowblowing job has been completed, allow the

engine to idle for a few minutes, to melt snow and ice ac-

cumulated on the engine.

8. Clean the snow thrower thoroughly after each use.
9. Remove ice and snow accumulation and all debris from

the entire snow thrower, and flush with water (if possible)

to remove all salt or other chemicals.  Wipe snow thrower

dry.

10. Before starting snow blower, always inspect augers and

impeller for ice accumulation and/or debris, which could

result in snow blower damage.

11. Check oil level before every start. Make sure the oil is at

the FULL mark on the oil fill cap/dipstick.