John Deere ST1332 ユーザーズマニュアル

25

MTF−051059L

Some adjustments will need to be made periodically to

properly maintain your snowthrower.
All adjustments in the MAINTENANCE section of this manual

should be checked at least once each season.

The following adjustment should be performed more than

once each season.
Auger and Traction Drive Belts should be adjusted after the

first 2 to 4 hours of use, again about mid−season and twice

each season thereafter (See To Adjust Belts paragraph in the

MAINTENANCE  section).

Auger Gear Box
The auger gear box is lubricated at the factory and should not

require additional lubrication. 

If for some reason the lubricant should leak out, or if the auger

gear box has been serviced, add Lubriplate GR132 Grease

or “Deere Multi−Purpose Lithium Grease”. Maximum 3−1/4

ounces, (92 grams) should be used.
Remove filler plug D (Figure 24 and Figure 25), once a year.

If grease is visible, do not add. If grease is not visible, use a

piece of fine wire, like a dipstick to check if there is grease in

the gear box. Mobilux EP1 and Shell Aldania EP1 are

suitable equivalents.

 

Figure 24

D

 

Figure 25

Filler

Plug

Bearings and bushings
All bearings and bushings are lifetime lubricated and require

no maintenance. 

1. Auger Shaft − Using a hand grease gun, lubricate the

auger shaft zerk fittings (A) every ten (10) operating

hours. Each time a shear bolt is replaced, the auger shaft

MUST be greased (Figure 24). (See To Replace Auger

Shear Bolt  in the MAINTENANCE section).

2. For storage or when replacing shear bolts, remove shear

bolts and lubricate auger shaft zerks.  Rotate augers sev-

eral  times on the shaft and reinstall the shear bolts.

Chute Rotation Gear
Lubricate the chute rotation gear with automotive type oil.

(see Figure 26).

Chute

Rotation

Gear

Figure 26