Roland XV-88 ユーザーズマニュアル
109
Chapter 7. Adding Effects
Chapter 7
• The output destination of the signal after passing
through the chorus is set with Output Assign parameter
or Select parameter (PATCH/EFFECTS/PATCH CHO
OUT)/(RHYTHM/EFFECTS/RHYTHM CHO OUT) (p.
158).
or Select parameter (PATCH/EFFECTS/PATCH CHO
OUT)/(RHYTHM/EFFECTS/RHYTHM CHO OUT) (p.
158).
• The output destination of the signal after passing
through the Reverb is set with the Output Assign
parameter (PATCH/EFFECTS/PATCH REV OUT)/
(RHYTHM/EFFECTS/RHYTHM REV OUT) (p. 160).
parameter (PATCH/EFFECTS/PATCH REV OUT)/
(RHYTHM/EFFECTS/RHYTHM REV OUT) (p. 160).
For more on how to set each effect, refer to the pages
shown below.
shown below.
• Multi-effects
→
• Chorus
→
• Reverb
→
5. Press [EXIT] to return to the PATCH PLAY/RHYTHM
PLAY page.
An asterisk
*
will be displayed at the left of the Patch/
Rhythm Set group. This indicates that the Patch/Rhythm
Set settings have been modified.
Set settings have been modified.
If you select another Patch/Rhythm Set in the group
with an asterisk
with an asterisk
*
, the modified Patch/Rhythm Set
settings will be lost. To keep these modified settings,
perform the save operation (p. 164).
perform the save operation (p. 164).
The Settings for Each Tone/
Rhythm Tone
Rhythm Tone
You can set the direct sound’s output method and the
amount of effect applied for each Tone or Rhythm Tone
individually.
amount of effect applied for each Tone or Rhythm Tone
individually.
1. After confirming you are in Patch/Rhythm Set mode,
2. Press [EDIT] to make the indicator light up, press the
[EFFECTS] function button, and press
or
to
display the OUTPUT page.
fig.07-04
3. Choose the Tone/Rhythm Tone for which you want to
make settings.
When Selecting a Tone
After turning off the [EDIT] indicator, use TONE SELECT
[1]–[4] to select the tone.
[1]–[4] to select the tone.
When Selecting a Rhythm Tone
Press the key that accesses the Rhythm Tone you wish to set.
After turning off the [EDIT] indicator, you can also use
TONE SELECT [1]–[4] to select the following setting.
After turning off the [EDIT] indicator, you can also use
TONE SELECT [1]–[4] to select the following setting.
TONE SELECT [1]: move to an octave lower key
TONE SELECT [2]: move to the semitone below
TONE SELECT [3]: move to the semitone above
TONE SELECT [4]: move to an octave higher key
4. Press
or
to move the cursor to the parameter
you’re going to modify.
Output Assign (Output Assign/Output Level★)
Sets the direct sound’s output method and volume for each
Tone or Rhythm Tone.
Tone or Rhythm Tone.
MFX
: Output in stereo through Multi-effects. You can also
apply Chorus or Reverb to the sound that passes through
Multi-effects.
Multi-effects.
OUTPUT A
: Output to the OUTPUT A (MIX) jacks in stereo
without passing through Multi-effects.
OUTPUT B
: Output to the OUTPUT B jacks in stereo without
passing through Multi-effects.
INDIV 1
: Output to the INDIVIDUAL 1 jack in mono without
passing through Multi-effects.
INDIV 2
: Output to the INDIVIDUAL 2 jack in mono without
passing through Multi-effects.