Creative E-MU ユーザーズマニュアル

Main Panel Controls

Xboard

19

This button selects the Basic MIDI channel for the keyboard and all controls.
To Select a MIDI Channel: Press the MIDI Channel button, then select the 
channel using the data slider, the Octave Transpose + and - buttons, or the 
Direct Patch Select buttons (Xboard 61 only), and press Enter.

In this mode, one MIDI Continuous Controller number is assigned to all 16 
knobs and each numbered knob transmits on the same-numbered MIDI 
channel. This gives you control of one parameter (such as volume or pan) for 
all 16 MIDI channels. See 

 for detailed information.

In this mode, pressed keys continue to play until they are pressed again to 
turn them off. This allows notes to be sustained for any length of time 
without having to hold down the keys. A range of latch keys can be defined 
using the “Latch High Note” and “Latch Low Note” edit parameters. See 

.

Knob Bypass disables the transmission of MIDI messages from the knobs or 
control pedal/footswitch to avoid abrupt parameter jumps in performance.
When Bypass is On, you can pre-set the knobs anywhere you like without 
sending MIDI controller messages. When you turn Bypass Off again, nothing 
is transmitted, but the knobs are now in the desired position for your perfor-
mance. When you turn a knob, the value of the new knob position will be 
sent.
This feature can also be used to set up any of the knobs the way you want, 
then send the values later using the Snapshot feature. See 

When this button is pressed, the stored current settings of all performance 
controls (knobs, wheels, footswitch/pedal) are transmitted. This feature can 
also be used in conjunction with the Knob Bypass control to setup, and then 
send a group of MIDI continuous controllers messages at once.
The Snapshot function is accessible only while in Play mode (i.e., whenever 
the Home LED is lit).

X Board.book  Page 19  Wednesday, April 12, 2006  10:44 AM