Creative E-MU ユーザーズマニュアル

Controller Knobs

E-MU Systems

20

The 16 Controller Knobs are designed to modify the sound during performance. 
MIDI Continuous Controller messages are transmitted whenever the knobs are 
turned (except when “Knob Bypass” is enabled).
Whenever a controller knob is turned, the current value of the knob is displayed 
on the LED. Next, the letters “CC” flash on the display, followed by the MIDI 
Continuous Controller assigned to the knob, then the letters “CH”, and finally the 
MIDI channel on which the knob currently sends. To set the CC channel numbers 
of the knobs see 

.

Any MIDI Continuous Controller number can be assigned to any knob. For 
instructions on setting this from the Xboard, see 

. For help setting this 

using the Xboard Control Software, see 

In this mode, one MIDI Continuous Controller number is assigned to all 16 knobs 
and each numbered knob transmits on the same-numbered MIDI channel. This 
gives you control of one parameter (such as volume or pan) for all 16 MIDI 
channels. See 

.

Using the Xboard Control software, any of the 16 Controller Knobs can be 
configured to run in 3D MIDI mode, or NRPN mode. For more information, see 

.

X Board.book  Page 20  Wednesday, April 12, 2006  10:44 AM