Korg Triton Studio ユーザーズマニュアル

If you have any questions regarding installation, please 
contact your local Korg distributor.

(** MB): SIMM’s are installed in SIMM slots 1–3. 

The capacity of each SIMM is shown in parentheses. When 
shipped from the factory, a 16 MB SIMM is already installed 
in SIMM slot 1.

(****): PCM expansion boards are installed in EXB-

PCM series slots 1–7. The type of each board is shown in 
parentheses.

Before you perform the installation, be sure to read the fore-
going section “Safety precautions” and “Please note when 
installing an option board/memory.”

A maximum of seven EXB-PCM boards can be installed 
simultaneously.
If you are installing a single EXB-PCM, it will function 
correctly when installed in any slot. For easiest installa-
tion, you should use the furthest slot (EXB-PCM Slot 1) 
first.

While performing the installation, be careful that you 
do not cut your hands on any sharp or pointed edges of 
the TRITON STUDIO or the option board.

You must leave the AC power cable disconnected until 
you have completed all steps of installing the option 
board.

1

Use a coin or similar object to turn the screw counter-
clockwise until the EXB-PCM/sampling memory (RAM) 
slot cover (located at the upper left of the front panel) is 
released. (Turn the screw counter-clockwise to loosen it, 
or clockwise to tighten it.)

2

Raise the EXB-PCM/sample memory (RAM) slot cover 
to the angle shown in the diagram, and remove it.

When you open the EXB-PCM/sample memory (RAM) 
slot cover, do not raise it too far toward the rear.

3

Remove the EXB-PCM from its packing pouch.

The EXB-MOSS option is installed.
The EXB-DI option is installed.
The EXB-mLAN option is installed
The CDRW-1 option is installed.

EXB-PCM/sample 
memory (RAM) slot cover