Korg Triton Studio ユーザーズマニュアル

6

Attach the cable as shown in the diagram. Firmly press 
the cable all the way into the connector.

Do not touch any part of the circuit board other than 
the connector to which you are connecting the cable.

7

With the connectors of the EXB-DI protruding from the 
rear panel of the TRITON-Rack, support the EXB-DI with 
one hand and use the two screws you removed to fasten 
the EXB-DI from the rear of the TRITON-Rack.

8

Reversing the procedure described in steps 1–5 of 
“Installing the EXB-MOSS,” reattach the EXB-MOSS/
EXB-DI cover.

9

After you have completed all the above steps, turn on the 
power and verify that the EXB-DI has been installed cor-
rectly. (“Checking after installation” 

Before you perform the installation, be sure to read the fore-
going section “Safety precautions” and “Please note when 
installing an option board/memory.”

While performing the installation, be careful of any 
sharp or pointed edges of the TRITON STUDIO or the 
option board.

You must leave the AC power cable disconnected until 
you have completed all steps of installing the option 
board.

1

Remove two screws from the mLAN cover plate that cov-
ers the EXB-mLAN installation slot on the rear panel, 
and remove the mLAN cover plate.

The two screws you removed will be used to fasten the 
EXB-mLAN in place. The cover you removed should be 
kept in a safe place, since it will be needed if you later 
decide to remove the EXB-mLAN.

2

From the TRITON STUDIO, pull out the cable that will 
be connected to the EXB-mLAN.

3

Remove the EXB-mLAN from its bag.

4

Disconnect the cable from the EXB-mLAN connector.

The cable you disconnected should be kept in a safe 
place. This cable may be required for connection if the 
EXB-mLAN is installed in another device that can use 
it.

Rear panel

Press all the way in

Connector

Cable

EXB-DI

mLAN cover plate

EXB-mLAN connector

Cable