Korg Triton Studio ユーザーズマニュアル

5

Using the three mLAN installation screws (included with 
the TRITON STUDIO), attach the mLAN installation 
plate (also included with the TRITON STUDIO) to the 
EXB-mLAN.

6

Connect the cable you pulled out in step 2 to the EXB-
mLAN connector. Firmly press the cable all the way into 
the connector.

7

Using the two screws you removed in step 1, attach the 
EXB-mLAN to the TRITON STUDIO.

8

When all steps have been completed, turn on the power 
and verify that the EXB-mLAN has been installed cor-
rectly. (“Checking after installation” 

If you have installed the EXB-mLAN into the TRITON 
STUDIO for the first time, you must perform the Initial-
ize operation. (

For details on connections between the EXB-mLAN and 
external devices, refer to the “EXB-mLAN owner’s 
manual.”

Before you perform the installation, be sure to read the fore-
going section “Safety precautions” and “Please note when 
installing an option board/memory.”

Never attempt to install an internal CD-R/RW drive 
other than the CDRW-1.

While performing the installation, be careful not to cut 
your hands on any sharp or pointed metal edges of the 
TRITON STUDIO or the CDRW-1.

You must leave the AC power cable disconnected until 
you have completed all steps of the installation.

1

Push off the CDRW-1 cover.
Slide the [EJECT] switch (located on the bottom of the 
TRITON STUDIO) in the direction of the arrow, and the 
drive bay cover on the side of the TRITON STUDIO will 
be pushed out.

2

Remove the CDRW-1 cover.
Hook your fingertip on the edge of the cover that was 
pushed out, and remove it in the direction of the arrow 
shown in the diagram.

Forcefully pulling the cover toward yourself may dam-
age the cover.

Keep the cover you removed, since it will be needed if 
you remove the CDRW-1.

3

Insert the CDRW-1.
Be sure that the drive is oriented in the correct direction.

EXB-mLAN

mLAN
installation plate

Viewed from below