Korg Electric Keyboard ユーザーズマニュアル

This adjusts the Decay Time and Slope Time of the filter EG 
and amp EG.
With an adjustment of +00, the value of the program param-
eters will be unchanged.
Positive (+)

 settings will lengthen the Decay Time and Slope 

Time beyond the values that were set. With an adjustment of 
+10

, the times will be 99.

 settings will shorten the Decay Time and Slope 

Time. With an adjustment of –10, the times will be 0.

This adjusts the “W/D(Wet/Dry)” setting of the insertion 
effect.
With an adjustment of +00, the value of the program param-
eters will be unchanged.
Positive (+)

 settings will raise the Wet level above the pro-

gram setting, and lower the Dry level. With an adjustment of 
+10

, the setting will be “Wet” - the effected signal only.

 settings will lower the Wet level below the pro-

gram setting, and raise the Dry level. With an adjustment of 
–10

, the setting will be “Dry” - the signal is unaffected.

This adjusts the master effect “Rtn1 (Return1)” and “Rtn2 
(Return2)” (7.2–1a) settings as a whole.
With an adjustment of +00, the value of the program param-
eters will be unchanged.
Positive (+)

 settings will raise the return levels above the 

program setting.
With an adjustment of +10, the setting will be 127 (maxi-
mum).
Negative (–)

 settings will lower the return levels below the 

program setting.
With an adjustment of –10, the setting will be 0.

■

☞ “Write Program,” “Select by Category” (1.1–1c)

While arpeggiator parameters are for the most part edited in 
PROG 6.1: Ed-Arp., Some major parameters can be edited 
here as well. When you are playing in PROG 1.1: Play, you 
can edit the arpeggiator in realtime, such as changing the 
arpeggio pattern etc.
You can also use the REALTIME CONTROLS C-mode 
[TEMPO], [ARP-GATE], and [ARP-VELOCITY] knobs to 
edit the arpeggio in realtime (☞BG p.27).

 ,   ,    ,   ,    ,   ]

Make settings for the program arpeggiator (☞“PROG: Ed-
Arp.”). These parameters can also be set from 6.1: Ed-Arp. 
setup page (☞6.1–1a).

■

☞ “Write Program,” “Select by Category” (1.1–1c)

Octave

Octave of OSC 1 and 2

Stretch

Transpose and Tune of OSC 1 and 2

OSC Bal

High Level and Low Level of OSC1 and 2

Level

Amp1 Level, Amp2 Level

Attack

Amp EG Attack Time, Start Level, Attack Level, 
Level Modulation S, Time Modulation A of Amp 1 
and 2, and Filter EG Attack Time of Filter 1 and 2

Decay

AmpEG Decay Time, Slope Time of Amp 1 and 2, 
Filter EG Decay Time and Slope Time of Filter 1 
and 2

IFX Bal

W/D (Wet/Dry) balance of the IFX effect

MFX Bal

Master Effect RTN1, 2 (Return1, 2)

1.1–3a

1.1–3b