Korg Electric Keyboard ユーザーズマニュアル

ページ / 269
119
SMPL
1.1
2.1
3.1
4.1
5.1
5.2
7.1
 5.2–1c: UTILITY
☞ “Delete SMPL,” “Copy SMPL,” “Move SMPL,” “Rename 
SMPL,” “SMPL To Stereo,” “Delete MS,” “Copy MS,” 
“Move MS,” “Rename MS,” “MS To Stereo/MS To 
Mono,” “Conv. To Prog,” “Keyboard Disp.” (1.1–3f)
Here you can make insert effect settings for use in Sampling 
mode.
When you set “BUS” (1.1–3a) to IFX, the external input 
sound from the rear panel AUDIO INPUT 1 and 2 jacks will 
be sent to IFX (insert effect). By selecting insert effect and 
making settings in this page, you can apply the insert effect 
to the signal entering through the external input, and sam-
ple the result.
☞ For details on insert effect, refer to p.155 “7. Effect Guide.”
In Sampling mode, master effects 1 and 2 and the mas-
ter EQ cannot be used.
Insertion effect settings in Sampling mode are not 
backed up when the power is turned off. If you wish to 
keep the insertion effect settings, you can use “Copy 
Insert Effect” (7.1–1a).
For example, you can copy the insertion effect settings 
of Sampling mode to a program or combination in 
order save them. When you write the program or com-
bination, the settings will be saved in internal memory. 
In Sampling mode, you can use “Copy Insert Effect” 
(7.1–1a) to copy these effect settings from the program 
or combination back into Sampling mode and use 
them.
7.1–1: Setup
Here you can select insert effects, switch them on/off, make 
chain settings, and specify the pan of the sound after pass-
ing through the insert effect.
These parameters are the same as in Program mode. ☞Pro-
gram mode “7.1–2: Setup”
 7.1–1a: UTILITY
☞ “Copy Insert Effect” (PROG 7.1–1c), “Select by Category” 
(PROG 7.1–2c)
7.1–2: IFX
Sets the effect parameters for the IFX effect that you selected 
in the Setup page (☞p.164–).
Effect Dmod (dynamic modulation) is controlled by the 
global MIDI channel specified in “MIDI Channel” 
(GLOBAL 2.1–1a).
SMPL 7.1: Insert Effect
7.1–1a