Korg Electric Keyboard ユーザーズマニュアル

These parameters set the gain of the trigger signal.
For example, if you do not want to apply compression to the high 
range, reduce the “High Offset” value down below the “Thresh-
old” level. In this way, the high range limiter will not respond, 
and compression will not be applied.

This effect mutes the input signal if its level is lower than the 
specified level. It also reverses the on and off operation of the 
gate, and uses Note On and Off messages to turn the gate on 
and off. 

The “Envelope” parameter selects whether the gate on/off is trig-
gered by the level of the input signal, or controlled directly by the 
modulation source. The Src parameter specifies the modulation 
source, selected from Off to G2+Dmod.
With “Envelope” = L/R Mix, the left and right channel signal mix-
ture will trigger the gate on/off. When L Only or R Only is 
selected, the gate is controlled by either of the channel signals.

This parameter reverses the Gate on/off operation. With a nega-
tive

 value, the gate is closed when the input signal level exceeds 

the Threshold. The gate operation controlled by the modulation 
source is also reversed.

This parameter sets the signal level below which Gate is applied 
when “Envelope” is set to L/R Mix, L Only, or R Only.
The Attack and Release parameters set the Gate attack time and 
release time.

This parameter sets the delay time of the Gate input. If the sound 
has a very fast attack, increase the delay time so that the signal 
will be input after the Gate is opened. This will preserve the attack 
part of the sound.

This distortion effect utilizes an Overdrive mode and a Hi-
Gain mode. Controlling the wah effect, the 3-band EQ, and 
the amp simulation will allow you to create versatile distor-
tion sounds. This effect is suitable for guitar and organ 
sounds.

i

W/D (Wet/Dly)

Dry, 1:99...99:1, Wet

(Source)

Off...Tempo

(Amount)
Sets the modulation amount of the effect balance

–100...+100

a

Envelope (Envelope Select)

Dmod, L/R Mix, L Only, R Only

Selects from Control via the modulation source, mixing the left and 
right signals, Only left, and Only right

☞

,

b

Env. Dmod Src (Envelope Dmod Source)

Off...G2+Dmp

Selects the modulation source that controls the gate when Envelope 
= Dmod

c

Threshold
Sets the level to which the Gate is applied

0...100

☞

d

Attack
Sets the attack time

1...100

☞

e

Release
Sets the release time

1...100

☞

f

Polarity

+, –

Switches between non-reversed and reversed Gate on/off

☞

g

Delay (Delay Time)
Sets the delay time of the gate input

0...100ms

☞

h

W/D (Wet/Dly)

Dry, 1:99...99:1, Wet

(Source)

Off...Tempo

(Amount)
Sets the modulation amount of the effect balance

–100...+100

+

a

Wah
Switches Wah on/off

Off, On

☞

,

(Source)

Off...Tempo

Selects the modulation source that switches the Wah on and off

(Sw)

Tggl, Mmnt

Selects the switching mode for the modulation source that switches 
the Wah on and off

☞

b

Sweep Rng (Wah Sweep Range)
Sets the range of Wah

–10...+10

☞

,

Src (Source)

Off...Tempo

Selects the modulation source that controls the Wah

☞

c

Mode (Drive Mode)

Overdrive, Hi-Gain

Switches between overdrive and hi-gain distortion

Drive
Sets the degree of distortion

1...100

☞

d

Pre Low-cut

0...10

Sets the low range cut amount of the distortion input

☞

+