Korg Electric Keyboard ユーザーズマニュアル

The “MIDI Channel” (3.1–1a) of timbres 1, 2, 3, 4, and 5 
are set respectively to Gch, Gch, 02, Gch, and 03. Their 
“Status” (3.1–1a) is set respectively to INT, Off, INT, Off, 
and INT. Assign arpeggiator A to timbres 2 and 3, assign 
arpeggiator B to timbres 4 and 5, and check “Arpeggiator 
Run A, B” (1.1–4a/5a, 6.1–1a).

• When the front panel [ARP ON/OFF] key is off, playing 

the keyboard will sound only timbre 1. (Timbres 2 and 4 
are receiving the Gch, but they will not sound since their 
“Status” is Off.)

• When you turn on the front panel [ARP ON/OFF] key, 

arpeggiator A will operate for timbres 2 and 3, and 
arpeggiator B will operate independently for timbres 4 
and 5. (Arpeggiators A and B are triggered by receiving 
note data on any MIDI channel of an assigned timbre, 
but in this example they are being triggered from the 
Gch

.)

When you play the keyboard, arpeggiator A will operate 
for timbres 2 and 3, but only timbre 3 whose “Status” is 
INT

 will sound. Similarly, arpeggiator B will operate for 

timbres 4 and 5, but only timbre 5 whose “Status” is INT 
will sound.
In this way, you can make settings so that a timbre does 
not sound when the arpeggiator is off, but sounds only 
when the arpeggiator is on.

■

☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)

This command copies arpeggiator settings.

1

Select “Copy Arpeggiator” to access the dialog box.

2

In “From” select the copy source (mode, bank, number) 
arpeggiator.
If you are copying from Combination, or Song, select 
either A or B to if you wish to copy settings from only 
one arpeggiator, or select A&B if you wish to copy the 
settings of both arpeggiators.

3

If you are copying from a Program, or are copying either 
A or B from Combination, or Song, select either A or B as 
the “To” copy destination.

4

To execute the Copy Arpeggiator command, press the 
[F8] (“OK”) key. To cancel without executing, press the 
[F7] (“Cancel”) key.

The Arp. A pages you make settings for arpeggiator A. The 
Arp. B pages you make settings for arpeggiator B. 

You can also use Utility “Copy Arpeggiator” (6.1–1c) to 
copy settings from another mode such as Program 
mode.

 ,   ,    ,   ,    ,   ]

These parameters are the arpeggiator A settings for the com-
bination.
(☞p.24 PROG 6.1: Ed–Arp.)

* These parameters can also be set in “1.1–4: Arp. A, 1.1–5: 

Arp. B”

☞ 1.1–1a

■

☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c), 

“Copy Arpeggiator” (6.1–1c)

6.1–2a

6.1–2c

6.1–2b