Atlas Sound TSD-MIX41 ユーザーズマニュアル
Owner’s Manual
TSD-MIX41
4x1 Mic/Line Mixer
AtlasSound.com
– 4 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Rear Panel Description
TSD Input/Output connections are removable for easy system wiring. The connector has a 3.5mm
pitch between pins.
1. DC Power Input - Each TSD that requires DC power comes with a 2 position connector for
an external 24VDC power supply (sold separately). Because of the TSD’s low power consumption,
a single external power supply may power more than one TSD. Please refer to the specifications
on current requirements in milliamps to match with the appropriate power supply. Note: It is
acceptable to exceed the current requirements of the TSDs but NOT safe to use a power supply
that is below the current requirement of the device.
2. Balanced Inputs 1-4 - Connects to balanced line or mic level sources. Your connection must be
mated properly to the input connector or signal loss and/or noise may occur. For gain or source
input type selection, refer to the “Dip Switch Function Identification” chart for proper input setting.
Note: Unbalanced line level inputs can be inserted with proper wire configuration by connecting
the (G) and (-) terminals together.
3. Balanced Line Output - Provides output when an input signal is present for connection to
balanced line level devices. Your output connections must be connected properly to the
connectors or loss and/or noise may be introduced into the signal. Note: Unbalanced line level
devices can be used with proper wire configuration by connecting the (G) and (-) terminals
together.
4. Cable Management Retainer Points - Each TSD includes two cable retainer straps for securing
the included cable management retainers. Remove one of the rear panel screws, align the
panel hole with a retainer and firmly tighten the screws.
3
2
1
4
4
4
4