Oregon Scientific BAR210U ユーザーズマニュアル

3

1. 

:  Increase  /  decrease  setting;  activate  / 

deactivate clock reception signal

2. RESET: Reset unit to default settings
3. AUTO ON / OFF: Select auto toggle mode
4. CLOCK: Set time and display mode
5. °C / °F: Select temperature unit and display mode
6. Battery compartment

           

1.  LED status indicator
2.  Wall mount hole
3.  Battery compartment 
4.  RESET hole 
5.  CHANNEL switch

Batteries serve as back up power supply for the clock.  

For  continuous  use  of  LCD  backlight,  always  plug  in 
the  adapter  socket.    Make  sure  the  socket  outlet  is 
easily accessible to the unit.

1.  Remove  the  battery  compartment  and  insert  the 

batteries, matching the polarities.

2.  Press RESET after each battery change.

 indicates main unit batteries are low.

The  main  unit  can  be  connected  to  only  1  remote 
sensor.
To set up the outside sensor:

1.  Open the battery compartment. 
2.  Select a channel then press RESET. 
3.  Close the battery door.
4.  Place the outside sensor within 30 m (98 ft) of the 

main unit using the table stand or wall mount.

The  transmission  range  may  vary  depending  on 

many factors. You may need to experiment with various 
locations to get the best results.

BAR210 EN R8.indd   3

2/15/08   12:10:30 PM