ZyXEL Communications vantage cnm ユーザーズマニュアル

 Chapter 7 Device Advanced Settings

Vantage CNM User’s Guide

This section shows you how to configure the Static Route screens. These screens may vary 
depending on which model you’re configuring. Please see the device’s User’s Guide for more 
information about any of these screens or fields.

Use this screen to tell the device about networks that are not directly connected to the device. 
To open this screen, click a device, click Device Operation in the menu bar and then click 
Device Configuration > Advanced > Static Route in the navigation panel.

Figure 94   Device Operation > Device Configuration > Advanced > Static Route

Incoming Start 

Port

Type a port number or the starting port number in a range of port numbers.

Incoming End 

Port

Type a port number or the ending port number in a range of port numbers.

The trigger port is a port (or a range of ports) that causes (or triggers) the device to 

record the IP address of the LAN computer that sent the traffic to a server on the 

WAN.

Trigger Start 

Port

Type a port number or the starting port number in a range of port numbers.

Trigger End 

Port

Type a port number or the ending port number in a range of port numbers.

Apply

Click Apply to save your changes back to the device. 

Cancel

Click Cancel to return to the previous screen.

Table 84   Device Operation > Device Configuration > Advanced > NAT > Trigger Port > Edit