ZyXEL Communications vantage cnm ユーザーズマニュアル

Chapter 7 Device Advanced Settings

Vantage CNM User’s Guide

The following table describes the labels in this screen.

Use this screen to edit a static route in the device. To open this screen, select a static route, and 
click Edit in the Device Operation > Device Configuration > Advanced > Static Route 
screen.

Figure 95   Device Operation > Device Configuration > Advanced > Static Route > Edit

The following table describes the labels in this screen.

Table 85   Device Operation > Device Configuration > Advanced > Static Route

#

This is the number of an individual entry.

Route Name

This is the name that describes or identifies this route. To delete a static route, 

erase the name and then click apply.

Active

This field shows whether this static route is active or not.

Destination

This parameter specifies the IP network address of the final destination. Routing is 

always based on network number. 

Gateway

This is the IP address of the gateway. The gateway is an immediate neighbor of the 

device that will forward the packet to the destination. On the LAN, the gateway must 

be a router on the same segment as the device; over the WAN, the gateway must 

be the IP address of one of the remote nodes.

Edit

Click Edit to set up a static route on the device.

Remove

Click Remove to delete a static route.

Table 86   Device Operation > Device Configuration > Advanced > Static Route > Edit

Route Name

Enter the name of the IP static route. Leave this field blank to delete this static 

route.

Active

This check box allows you to activate/deactivate this static route.