3M 747 ユーザーズマニュアル
12
Important Note:
When operating on batteries, the power saver function minimizes battery drain, although a very
small amount of current is still required by the tester. Turn the power switch off to completely
disconnect the batteries.
When operating on batteries, the power saver function minimizes battery drain, although a very
small amount of current is still required by the tester. Turn the power switch off to completely
disconnect the batteries.
2.5 Wall Mounting
The supplied Wall-Mount Board allows the 3M
The supplied Wall-Mount Board allows the 3M
™
Shoes and Wrist Strap Tester 747 to be easily
mounted on the wall while still being readily
removable.
As shown in the figure below, the board is affixed
to the wall with three screws (either M4 machine
screws or 4.1 mm diameter wood screws). The
Shoes and Wrist Strap Tester 747 is then attached
to the board by align in the back-side mounting
holes over the hooks on the board.
mounted on the wall while still being readily
removable.
As shown in the figure below, the board is affixed
to the wall with three screws (either M4 machine
screws or 4.1 mm diameter wood screws). The
Shoes and Wrist Strap Tester 747 is then attached
to the board by align in the back-side mounting
holes over the hooks on the board.
Important Note:
Screws are not included. Please use either M4 machine screws or wood screws with a nominal
diameter of 4.1 mm for mounting. Either flat head or round head screws may be used.
Screws are not included. Please use either M4 machine screws or wood screws with a nominal
diameter of 4.1 mm for mounting. Either flat head or round head screws may be used.
3.0 Testing
When used as a stand-alone tester (that is, when not using the external output),
the SIGNAL OUT test result output selector switch should be set to either
WRIST or SHOES.
With the SIGNAL OUT switch set to either of these positions, both ESD shoes
and wrist tests can be performed.
the SIGNAL OUT test result output selector switch should be set to either
WRIST or SHOES.
With the SIGNAL OUT switch set to either of these positions, both ESD shoes
and wrist tests can be performed.
To reduce the risks associated with electrostatic discharge (ESD), which, if not avoided, may result in
property damage to electronic components or assemblies being handled.
• Perform operational verification test to ensure proper operation of the 3M
property damage to electronic components or assemblies being handled.
• Perform operational verification test to ensure proper operation of the 3M
™
Shoes and Wrist Strap
Tester 747 as required.
CAUTION