Grizzly G0656X ユーザーズマニュアル
G0656 8" Jointer with Built-In Mobile Base
-15-
9. Slide the motor upward, and place the V-belt
around the cutterhead pulley and the motor
pulley.
pulley.
10. Slide the motor down to rest on the V-belt.
11. Place a straightedge against both pulleys
(
Figure 10) and check the alignment of
the two pulleys to make sure that they are
aligned and that the V-belt is straight up and
down (see
aligned and that the V-belt is straight up and
down (see
Figure 11).
— If the pulleys are aligned, tighten the motor
bracket fasteners and go to
Step 15.
— If the pulleys are NOT aligned, perform
Steps 12–14.
12. Remove the V-belt and loosen the motor
mount fasteners (see
Figure 9).
Figure 11. Pulleys aligned.
Cutterhead
Pulley
Motor
Pulley
���������
Figure 13. Fence tilt lever installed.
18. Slide the cutterhead guard shaft down through
the mounting hole on the table.
Note: The guard may not fully seat in the hole
initially; however, rotating the guard will allow
the shaft to fully seat in the hole.
initially; however, rotating the guard will allow
the shaft to fully seat in the hole.
Figure 10. Checking belt alignment.
13. Shift the motor horizontally as needed to
align the motor pulley with the cutterhead pul-
ley, then replace the V-belt.
ley, then replace the V-belt.
14. Tighten the motor mount fasteners.
15. Secure the infeed and outfeed handwheels
with the cap screws and flat washers already
mounted on the handwheel shafts, as shown
in
mounted on the handwheel shafts, as shown
in
Figure 12.
16. Secure the handwheel handles to each of the
the handwheels, as shown in
Figure 12.
17. Install the fence tilt lever, as shown in Figure
13.
Figure 12. Securing the handwheel handle.
Straightedge