Netgear UTM25-100NAS ユーザーズマニュアル

Network and System Management

10-15

2. Enter the settings as explained in 

.

3. Click Apply to save your settings.

The configuration settings of the UTM are stored in a configuration file on the UTM. This file can 
be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory default 
settings.

Once the UTM is installed and works properly, make a back-up of the configuration file to a 
computer. If necessary, you can later restore the UTM settings from this file. 

Do You Want to 
Enable SNMP?

Select one of the following radio buttons:
• Yes. Enable SNMP. 
• No. Disable SNMP. This is the default setting.

Read Community The community string to allow an SNMP manager access to 

the MIB objects of the UTM for the purpose of reading only. 
The default setting is public.

Set Community

The community string to allow an SNMP manager access to 
the MIB objects of the UTM for the purpose of reading and 
writing. The default setting is private.

Contact

The SNMP system contact information that is available to 
the SNMP manager. This setting is optional.

Location

The physical location of the UTM. This setting is optional.

Enter the IP addresses of the computers and devices to which you want to grant read-only (“GET”) or 
write (“SET”) privileges on the UTM. Separate IP addresses by a comma. To allow any trusted SNMP 
host access, leave the field blank, which is the default setting.

Enter the IP addresses of the SNMP management stations that are allowed to receive the UTM’s SNMP 
traps. Separate IP addresses by a comma. If you leave the field blank, which is the default setting, no 
SNMP management station can receive the UTM’s SNMP traps.